bind 9(.2.4) on solaris 10

[Mark Andrews]

> I wish it were that simple for me. Unfortunately I have corporate 
> requirements and restrictions to work with and one of them happens to be 
> to have IPv6 disabled everywhere. =P

	So short sighted ...
	One could argue that 6to4 is only IPv4 :-)
 
> Speaking of which, there appears to be a named.conf directive called 
> "listen-on-v6". Would the "listen-on" version imply IPv4 only? If so, 
> that would be an acceptable workaround.
> 
> -Alex

	No.  Named will make queries over IPv6 even if it won't accept
	them.
 
> Mark Andrews wrote:
> > 	You know there is a simple solution.  Get IPv6 connectivity.
> > 	If your ISP doesn't provide it there are plenty of tunnel
> > 	brokers that will provide connectivity, often for free.
> > 	That's how my home network get IPv6 connectivity.
> > 
> > 	If you don't won't is use a tunnel then set up 6to4 support.
> > 
> > 	Mark
> > 
> > 	Note you will need IPv6 connectivity within the next few years.
> > --
> > Mark Andrews, ISC
> > 1 Seymour St., Dundas Valley, NSW 2117, Australia
> > PHONE: +61 2 9871 4742                 INTERNET: Mark_Andrews at isc.org
> > 
> 
> 
--
Mark Andrews, ISC
1 Seymour St., Dundas Valley, NSW 2117, Australia
PHONE: +61 2 9871 4742                 INTERNET: Mark_Andrews at isc.org