How do you control what NIC the resolver uses?

[Quadri, Jay]

Checkout  http://www.isc.org/products/BIND/docs/config/options.html


for Interfaces

 listen-on [ port ip_port ] { address_match_list }; ]
  

-----Original Message-----
From: kevin [mailto:kevin.d at taligent.net]
Sent: Wednesday, August 23, 2000 1:27 PM
To: bind-users at isc.org
Subject: How do you control what NIC the resolver uses?



Hello,

I am setting up a certain system configuration and i need
to control what ethernet card the resolver uses.

Default installation is no good as it can be any NIC.
Fine grained control a must.

System is linux.

Firstly can this be done?

Do I need to install resolver source files then compile with
certain parameters?

I am not sure if resolver is part of Bind (i don't think it is).


All help appreciatted

Kevin