Cannot stop/start new BIND 8.2.1
Frank Lepera
flep at bnl.gov
Wed Jun 23 14:06:45 UTC 1999
marka at isc.org wrote:
> > Folks...
> >
> > I just installed latest release of BIND (8.2.1).
> > Noticed a NEW NDC module among other new modules. When attempting
> > to stop/start the nameservice using the NEW /usr/sbin/ndc module
> > I get the following error...
> >
> > # /usr/sbin/in.ndc stop
> > ndc: error: ctl_client: evConnect(fd 3): No such file or directory
> > ndc: error: cannot connect to command channel (/etc/ndc)
> >
> > Can someone point me in the right direction regarding this problem?
> >
> > --
> > Frank Lepera flep at bnl.gov
> > Network Engineering Section, ITD
> > Brookhaven National Laboratory [516]344-4183
> >
> >
> >
> >
> What errors were logged when named started up?
None! named never started using ndc.
>
> You are certain that you are running 8.2.1 and not 8.2 or ealier
> (ndc support was broken on Solaris for 8.2 and earlier versions
> used signals)?
Yes! The "src/Version" file in the distribution I downloaded says "8.2.1".
>
> Can you send all the messages between "named starting" and
> "ready to answer"?
"named" doesn't start.
>
> Are you running named as a user other than root?
No. Running as root.
>
> You can still use ndc in signal mode (ndc -s) if you have to.
Will try this!
>
>
> Mark
> --
> Mark Andrews, Internet Software Consortium
> 1 Seymour St., Dundas Valley, NSW 2117, Australia
> PHONE: +61 2 9871 4742 INTERNET: marka at isc.org
--
Frank Lepera flep at bnl.gov
Network Engineering Section, ITD
Brookhaven National Laboratory [516]344-4183
More information about the bind-users
mailing list