upgrade from 4.9.5 to Bind 8.2.2p5

[Danny Mayer]

	Which nslookup are you running?  Are you sure that the bind 8 is running?
  What does the event viewer tell you when you run it?  Did you perform the
  conversion from bind4 to bind8 format using the perl script provided?

		What IP address does nslookup try to get?  Is it in your resolv.conf
  located in system32/Drivers/etc?  Does that nameserver have a PTR
  record for it's IP address?  And who owns that record?

		I don't remember if Bind4 has an uninstall.  If you are not comfortable
  with the registry, just leave the data there and use the Control Panel to
  disable it.

				Danny

At 08:49 PM 10/24/00 +0300, muheeb wrote:
>
>hello All,
>
>I just upgraded my Bind to Bind8.2.2. However, I was unable to uninstall or
>find a way to uninstall Bind4.
>
>Bind 8.2.2 p5 service seem to run fine and it loads all my db files. But
>when I do nslookup it gives me the error message that it could not find the
>default servers.
>
>And when I go and start 4.9.5 nslookup works fine..
>
>Is there a way that I completely remove Bind 4 and clear all the registry
>entries for it.
>
>Muheeb
>
>----- Original Message -----
>From: Len Conrad <lconrad at Go2France.com>
>To: <bind-users at isc.org>
>Sent: Friday, October 20, 2000 9:26 AM
>Subject: BIND 8.2.3 T6B port to NT4 & W2K available
>
>
>>
>> Thanks to Danny Mayer:
>>
>> http://bind8nt.meiway.com/download.cfm (bottom of the page)
>>
>> Len
>>
>> http://BIND8NT.MEIway.com: ISC BIND 8.2.2 p5 & 8.2.3 T6B for NT4 & W2K
>> http://IMGate.MEIway.com:  Build free, hi-perf, anti-spam mail gateways
>>
>>
>>
>