/var/run/ndc= not created

[Nick Bryant]

Ok it isnt made when named is run - which isnt really a problem as named
works fine... its just everytime i want to do a named.reboot or .reload
i get the ndc error i mentioned below:

> > ndc: error: ctl_client: evConnect(fd 3): Connection refused
> > ndc: error: cannot connect to command channel (/var/run/ndc)

which make perfect sence as the command channel isnt there! Any ideas?

N

> -----Original Message-----
> From: Mark.Andrews at iengines.com [mailto:Mark.Andrews at iengines.com]
> Sent: 30 December 1999 22:51
> To: Nick Bryant
> Cc: 'bind-users at isc.org'
> Subject: Re: /var/run/ndc= not created 
> 
> 
> 
> > 
> > Hi,
> > 
> > Just installed Bind 8.2.2 (patch 5). It didnt create the 
> /var/run/ndc=
> > sockets file during make install as it normally does. 
> 
> 	"make install" does not create this.
> 	It is created when named is run and normally destroyed when
> 	named exits.
> > 
> > So now i get errors like:
> > 
> > ndc: error: ctl_client: evConnect(fd 3): Connection refused
> > ndc: error: cannot connect to command channel (/var/run/ndc)
> > 
> > Anyone know how to create it manually? 
> 
> 	Run named or start it via ndc.
> 
> 	Mark
> > 
> > Thanks
> > 
> > Nick
> > 
> > 
> --
> Mark Andrews, Internet Engines Inc. / Internet Software Consortium
> 1 Seymour St., Dundas Valley, NSW 2117, Australia
> PHONE: +61 2 9871 4742                 INTERNET: 
> Mark.Andrews at iengines.com
>