[Kea-users] HA survivor not taking over avec after communication interrupted with partner

[Alexandre Lessard]

Hello everyone,

I'm new here! I'm working for an ISP as a network administrator.
Furthermore, I got about 7 years of experience doing all sort of IT
stuff for this company. I've been using and configuring Kea DHCP for
about 2 weeks now. Prior to that, I was using ISC DHCP, but since it's
now deprecated, I'm preparing two new servers to migrate all customers
on them.

The setup:
The setup is DHCP relay with two Kea servers in HA hot-standby. There
is three particularity that I want to mention right now.

First, because I couldn't find an out-of-the-box solution, I made a
script that replicate the configuration through the API on both server
when they are restarted. I don't think it interferes with the service
as it is run prior to the service startup, but I don't want to
overlook it either.

Second, they both have an IP configured on their loop back interface
to be use kind of like an any cast address. That being said, I don't
use them for the HA, it's only used by the Relay agents.

Third, they are Proxmox containers. I don't think it's problematic but
tell me if I'm wrong, I will make VMs for them.

My problem:
When I simulated an outage by stopping the server1, only 2 (test2 and
test3) of the 4 subnets recover eventually. Even if they recover, it
takes about 5 minutes. As much as I understand, it's supposed to be
configured at 1 minute. The two other subnets never recovers.
Why some subnets never recover?
Why the 2 that recover take so long?

I observed that the state of server2 stays to "hot-standby" even if
the remote communication is interrupted.

I have been working on fixing that for more than 10 hours now.
Likewise, I really don't know what to look for anymore.

The config:
The Control Agents have almost default configuration, except for the
http-host that is set to the IP interface that receive the request
(eth0).

The Dhcp6 server is disabled.

Has for the Dhcp4 config, it has been saved through the API, so it is
massive! All default configs have been written in the config file. For
this reason, I won't post it here if not required to avoid sending a
wall of config. I've put it on a public repository of GitHub:
https://github.com/AlexTargo/Kea-Dhcp

If I'm missing anything, let me know, and I'll share it as soon as possible.

I hope someone have good pointers for me.

Regards
Alex