DHCP failover - first startup of primary fails with no secondary installed

[Nicola Volpini]

On 05/09/2013 09:58 AM, Steven Carr wrote:
> On 9 May 2013 08:43, Nicola Volpini <nicola.volpini at kambi.com> wrote:
>> I'd like to add we had the same issue on a different site. We solved it
>> by installing both the primary and the secondary and letting them sync
>> for the first time. Is this step a hard requirement I missed?
> Yes, the first initial sync is required.

Thanks Steven. Mistery solved then!
Regards,
Nicola

--
Nicola Volpini
Infrastructure Operations Engineer


CONFIDENTIALITY NOTICE: This email message (and any attachment) is intended only for the individual or entity to which it is addressed. The information in this email is confidential and may contain information that is legally privileged or exempt from disclosure under applicable law. If you are not the intended recipient, you are strictly prohibited from reading, using, publishing or disseminating such information and upon receipt, must permanently delete the original and destroy any copies. We take steps to protect against viruses and other defects but advise you to carry out your own checks and precautions as Kambi does not accept any liability for any which remain. Thank you for your co-operation.