No subject
Fri Feb 17 00:23:59 UTC 2012
will establish network connectivity - "ifup eth0" (with BOOTPROTO=dhcp) has
no patience and "dhcpd" (with no broadcast interfaces available) has no
patience. Did I mention that this dhcp client is also my dhcp server
machine? Server and client are coincident.
I have tried some silly things:
"dhcpd lo" -- that works (dhcpd runs), but is totally useless.
"dhcpd eth0" with eth0 down, -- that almost works - if I knew how to
configure subnet 0.0.0.0 J
A less silly thing that I tried was "dhclient eth0 &; dhcpd" Here the
interface comes up and broadcasts DHCPDISCOVER, but dhcpd fails to recognize
eth0 in this interim state - even though ifconfig shows "UP BROADCAST
RUNNING MULTICAST." and dhcpd will not run. The DHCPDISCOVER broadcasts
fall on deaf ears.
So, I really have a two questions and only one is a dhcp question. If I
knew where to post the "'ifup eth0' patience" question, I would, but even
still, there is a dhcp question. Why doesn't dhcpd recognize eth0 in the
provisional state established by dhclient? Alternatively, how can I dhcp
configure the network interface on the dhcp server itself? Seems like that
should be trivial.
Chris.
Fill what's empty, empty what's full, and scratch where it itches.
Life is a journey, not a destination ...
> -----Original Message-----
> From: dhcp-users-bounce at isc.org
> [mailto:dhcp-users-bounce at isc.org] On Behalf Of Tom Greaser
> Sent: Wednesday, November 15, 2006 8:26 AM
> To: dhcp-users at isc.org
> Subject: Re: Startup sequence
>
> find the run level your system starts in guessing 3
>
> mv /etc/rc3.d/S??dhpd to have a number after your S??network statement
>
> my rh4 box
> S10network S65dhcpd
More information about the dhcp-users
mailing list