dhcpd 3.0.1 stops responding to requests

[Wil Birkmaier]

Thanks Chuck, I will give that a try.

On another note, I turned off ddns intermit setting as well as put it in
stand alone mode.  It has been running for around 10 hours, so I shall
see how that goes as well.

Thanks!

Wil

-----Original Message-----
From: dhcp-users-bounce at isc.org [mailto:dhcp-users-bounce at isc.org] On
Behalf Of Chuck Anderson
Sent: Monday, May 22, 2006 5:24 PM
To: dhcp-users at isc.org
Subject: Re: dhcpd 3.0.1 stops responding to requests

On Mon, May 22, 2006 at 11:00:13AM -0700, Wil Birkmaier wrote:
> Hello All, I have tried searching thru the archives as well as google
> the last couple days and have come to my wits end trying to figure
this
> one out.  The only thought I have at this point is the failover has
> problems with using other ports (Using 521 instead of 520) or WANs

I don't think so.  I run multiple instances of failover on the same 
dhcpd, each one using a different port starting at 520 and going up to 
523.  I also set the peer port to the same port number.

>         mclt 600;
>         split 255;
>         load balance max seconds 3;
> }

I think I read on here once that the split 255 may cause an issue.  
I've always used the default split of 128.

_______________________________________________________________________
Notice:  This email message, together with any attachments, may contain
information  of  BEA Systems,  Inc.,  its subsidiaries  and  affiliated
entities,  that may be confidential,  proprietary,  copyrighted  and/or
legally privileged, and is intended solely for the use of the individual
or entity named in this message. If you are not the intended recipient,
and have received this message in error, please immediately return this
by email and then delete it.