Notify message from slaves

[Matus UHLAR - fantomas]

Hello,

please configure your mailer to wrap lines below 80 characters per line.
72 to 75 is usually OK.

Thank you.

On 02.03.10 14:02, Fuat Demir (Garanti Teknoloji) wrote:
> I have 2 slave 1 master server.
> master is located in different subnet from the slaves.
> Lets say, 10.1.1.1 (ns1) and 10.1.1.2 (ns2) are the real ip addresses of the slaves which have public NAT address for allowing queries from internet for authoritive zones. These public address lets say 1.1.1.1 (ns1) and 1.1.1.2 (ns2).
> In conf file of slaves i have a statement that "notify no".

where? in the options {} statement? in the view {} statements? Or in the
zone {} statement for xxx.com?

> When i configured conf file and reconfigure in slaves, i see transfer logs like this,
> 
> in the xfer log of ns1, it says "notify: info: client 1.1.1.2#25998: received notify for zone 'xxx.com'
> 
> in the xfer log of ns2, it says "notify: info: client 1.1.1.1#25998: received notify for zone 'xxx.com'
> 
> Please note that, ns1 recieves notify form the public address of ns2 and ns2 recieves notify from the public address of ns1.
> In both slave server, domain names for ns1 and ns2 are the public addresses of itselves.

check all notify settings in config file. Maybe the one you see is not the
one that applies.
-- 
Matus UHLAR - fantomas, uhlar at fantomas.sk ; http://www.fantomas.sk/
Warning: I wish NOT to receive e-mail advertising to this address.
Varovanie: na tuto adresu chcem NEDOSTAVAT akukolvek reklamnu postu.
BSE = Mad Cow Desease ... BSA = Mad Software Producents Desease