Slave server not using the IP set using transfer-source
Mark Andrews
marka at isc.org
Wed Aug 5 15:17:13 UTC 2009
In message <00163646d5c2137e6b0470660910 at google.com>, mrkbkr at gmail.com writes:
>
> I am using the configuration options shown in that faq, but I am running
> into a problem when my master server send a NOTIFY to the slaves. I have a
> zone with the same name in all four views. When the master send a notify
> for that zone to the slaves, the slave query the master to see what the
> serial is. When they do this they are sending the query through their
> default IP and not the IP I have set as the transfer source for that
> domain. Since they are using their default IP they are getting a serial of
> the same zone in a different view and not requesting the updated zone file
> from the master. The slave servers are getting the new zone file when doing
> a refresh call to the master server, since they are using the
> transfer-source for that operation. Is there anything I can do besides
> lowering the refresh interval to 5 minutes?
>
>
> Mark
Re-read the FAQ. It shows you how to do it. You need to make
sure the out going notify matches the appropriate view on
the slave. There are enough controls in named to do this.
The FAQ has 2 view examples of how to do this. Extrapolating
to more views really should not be hard.
Mark
--
Mark Andrews, ISC
1 Seymour St., Dundas Valley, NSW 2117, Australia
PHONE: +61 2 9871 4742 INTERNET: marka at isc.org
More information about the bind-users
mailing list