Zone just not loading or erroring
Bob Vance
bobvance at alumni.caltech.edu
Tue May 15 16:13:45 UTC 2001
Somebody probably cut-n-pasted from a 'vi' session -- 'vi' fills the
screen with lines beginning with "~" if the screen is not full of lines
from the edited file.
-------------------------------------------------
Tks | <mailto:BVance at sbm.com>
BV | <mailto:BobVance at alumni.caltech.edu>
Sr. Technical Consultant, SBM, A Gates/Arrow Co.
Vox 770-623-3430 11455 Lakefield Dr.
Fax 770-623-3429 Duluth, GA 30097-1511
=================================================
-----Original Message-----
From: bind-users-bounce at isc.org [mailto:bind-users-bounce at isc.org]On
Behalf Of Tuc
Sent: Tuesday, May 15, 2001 11:34 AM
To: bind-users at isc.org
Subject: Re: Zone just not loading or erroring
Hi,
Well, we found the problem, but don't know why.
Using "od -a", we found that the last line of the files that
didn't want to load were "~ " (Without
the quotes.
Is the tilde some sort of special character? Why didn't we get
any indications in syslog, etc.
Still interested what "state" is and how to decode.
Thanks, Tuc/TTSG Internet Services, Inc.
>
>
> Hi,
>
> We are having an issue with 8.2.3-REL.
>
> When we tell it to load the domains, it appears so, but after a
> certain point in the file it doesn't. If we comment out the 2-3
entries before
> the line, the next 2-3 still won't load.
>
> Syslog is cranked quite high, with no output we can see that would
> give an indication.
>
> The only thing we notice is that on a dump, good zones show :
>
> ; time=0, lastupdate=0, serial=2001051101,
> ; refresh=0, retry=3600, expire=604800, minimum=86400
> ; ftime=989608583, xaddrcnt=0, state=0041, pid=0
>
> And the bad zones show
>
> ; time=0, lastupdate=0, serial=2001051501,
> ; refresh=0, retry=3600, expire=604800, minimum=86400
> ; ftime=0, xaddrcnt=0, state=0140, pid=0
>
>
> Whats the "state", and how do we decode it?
>
> Thanks, Tuc/TTSG Internet Services, Inc.
>
>
>
More information about the bind-users
mailing list